Skip to main content

How to Build Chassis Robot with Arduino

Materials:​

Attaching the Motors to the Base​

  1. Screw on the support rods in the middle, top, and bottom of the left and right side of the board

check out the wiring section to see how to connect the wires to the motors

  1. Flip the structure over so the rods are facing down
  2. Push through the 't' shaped piece in the provided slot
  3. Snap on the corresponding black gears to the inner side of the motor axle
  4. Line up the holes of the motor to another 't' shaped piece and insert the long screw in the loacted holes

  1. Screw on the nut to the bolt to secure the motor in place

Repeat steps 3-5 for the rest of the motors

Attching the Top Base and Wheels​

  1. Snap in the wheels to the outer side of the motor

  1. Flip the structure and feed the wires through the located slots, making sure to keep the wire pairs seperated from other pairs

  1. Place the second base board on top of the support rods

  1. Screw in the screws to the rods to attach the piece into place

Attaching the Arduino Board​

  1. Connect the Motor shield to the Arduino board
  2. Use the provided double sided sticky tape to secure the board onto the robot
  3. Apply the double sided sticky tape to the back of the battery pack as well to secure that into place

check out wiring section to see how to wire in the wires